HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

Module J8702A is not working properly

 
Lactalis
Occasional Visitor

Module J8702A is not working properly

My switch core has 8 ethernet modules J8702A, but after a power outage 4 modules stop working G, H, I and J)

Bellow output from show module is showing "Booting", What Can I do  to fix that ?

show module

Status and Counters - Module Information

Chassis: 8212zl J9091A Serial Number: SG029BY052
Allow V1 Modules: Yes

Core Mod
Slot Module Description Serial Number Status Dump Ver
---- -------------------------------------- -------------- -------- ----- ---
MM1 HP J9092A Management Module 8200zl SG832BP085 Active YES 1

SSM HP J9095A System Support Module SG029BZ00Y

FM1 HP J9093A Fabric Module 8200zl SG028BQ00Z Enabled - 1
FM2 HP J9093A Fabric Module 8200zl SG028BQ064 Enabled - 1

A HP J8706A 24p SFP zl Module SG026BD031 Up NO 1
B HP J8706A 24p SFP zl Module SG026BD07R Up NO 1
C HP J8702A 24p Gig-T zl Module SG028AT13D Up NO 1
D HP J8702A 24p Gig-T zl Module SG028AT13B Up NO 1
E HP J8702A 24p Gig-T zl Module SG028AT16P Up NO 1
F HP J8702A 24p Gig-T zl Module SG028AT19G Up NO 1
G Booting -
H Booting -
I Booting -
J Booting -

 

1 REPLY
parnassus
Honored Contributor

Re: Module J8702A is not working properly

How many (and which types of) Power Supply units the HP ProCurve 8212zl chassis actually has in operational state (working)?

One, two, three or four J8712A Power Supply units (PoE power available: up to 273 Watt per each PS unit installed) or one, two, three or four J8713A Power Supply units (PoE power available: up to 900 Watt per each PS unit installed). Mixing of J8712A and J8713A units together is not recommended at all.

What does the system log report during boot (provide other info, like: software version, flash status, etc.)?

What's about LEDs patterns (see here for troubleshooting) on Switch MM and Modules?