Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

Monitor port configuration HP 2920-48G Switch (J9728A)

 
Occasional Visitor

Monitor port configuration HP 2920-48G Switch (J9728A)

Hello

Is it possible to configure a HP 2920-48G Switch (J9728A, WB.16.02.0012, ROM WB.16.03) in such a way that the monitoring is only active for some defined vlans (multiple)?

Ports 1-10 are configuted as tagged with these vlans 20, 30, 40, 50.

I would like to monitor vlan 20, 30 and 40 on all of them and output everything on port A2.

Thank you very much

Regards Mattia

 

 

2 REPLIES 2
Honored Contributor

Re: Monitor port configuration HP 2920-48G Switch (J9728A)

Have you tried to monitor VLANs instead of Ports and thus mirroring VLANs traffic (instead of Ports traffic) to monitor Ports(s)?

I'm not an HPE Employee
Kudos and Accepted Solution banner
Occasional Visitor

Re: Monitor port configuration HP 2920-48G Switch (J9728A)

Hello

Yes, I've tried but the command doesn't seem to be supported on the HP 2920-48G Switch (J9728A)

With the command "(config)# vlan 600 monitor" I get  "Invalid input: monitor"

What I would rather like to do is first choose which port to monitor and then filter them and just select some vlans.

Regards Mattia