Aruba & ProVision-based
1748154 Members
3703 Online
108758 Solutions
New Discussion

Problem With Vlan

 
SOLVED
Go to solution
ahmad_husain
Visitor

Problem With Vlan

Hello,

I have problem with Vlan in HP procruve switch 2610, ihave two vlan one for the data and 2nd for the CCTV.

Vlan1  default primary

vlan12 CCTV 

when i tag the primary 27-port to cctv valn the data vlan1 not work, when vlan-12 untage frm 27 port the data vlan work but the vlan12 CCTV ports not work

Please give solution of this problem 

 

Thanks 

 

 

 

6 REPLIES 6
Vince-Whirlwind
Honored Contributor
Solution

Re: Problem With Vlan

We need additional details:

2610 switch config

network diagram

config for whichever device is doing your inter-VLAN routing.

shinepothen
Frequent Advisor

Re: Problem With Vlan

As i understood from  your issue you are having problem connecting two vlan (Vlan 1 & Vlan 12)on a single port ?

what is the device connected to port 27?

to help you out bettwe we will need your current switch configuration,network topology.

sh run ,sh cdp nei detail,sh vlan 12 ,sh vlan 1,sh trunk,sh int brief.

ahmad_husain
Visitor

Re: Problem With Vlan

please find the attachment

27 port linked with the core switch 

ahmad_husain
Visitor

Re: Problem With Vlan

please find the attachment

27 port linked with the core switch 

 

 

Linkk
Frequent Advisor

Re: Problem With Vlan

As I understand, the link on interface 27 to the other switch is not working correctly.

You need to configure the following on both switches:

Switch "F2_SW":

vlan 1 untagged 27
vlan 12 tagged 27

Core Switch (behind interface 27):

vlan 1 untagged D8 (insert the real interface here)
vlan 12 tagged D8  (insert the real interface here)

The devices in the same VLANs can now communicate with each other. Of course, you still need a routing device and a configured default gateway on the devices for inter-VLAN communication.

shinepothen
Frequent Advisor

Re: Problem With Vlan

Thank you for shairng the outputs.

your switch F2_SW is looking good in configuration

you have port 27 untagged in vlan1 and tagged in vlan 12.

Now we will have to look the configuration on the Core SW,

Please share the similar config from the core sw so that we will get an idea on the config.

you will have to do the similar config which the above post suggest so that your issue get fixed.

vlan 1 untag and vlan 12 tagg on the said port.