- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Problems with LACP trunking Core 8212zl - Access 2...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2012 05:53 AM
08-23-2012 05:53 AM
Two Coreswitches (8212zl) connected via distributed trunking are working together.
All Access-Switches (2910al) are connected in the same configuration.
! Access-Switch
; J9148A Configuration Editor; Created on release #W.15.08.0007
; Ver #02:11.05:16
trunk 47-48 trk1 lacp
! Core-Switces
; J9091A Configuration Editor; Created on release #K.15.07.0008
; Ver #02:1b.2f:36
switch-interconnect Trk1
trunk C1,I1 Trk1 Trunk
trunk A1 Trk10 LACP
trunk A3 Trk11 LACP
trunk A5 Trk12 LACP
Everything runs fine, but after an failure-test (we take out the active CPU - the secondary started) all LACP-Links are in "Failure" Status.
LACP Trunk Port LACP Admin Oper
Port Enabled Group Status Partner Status Key Key
---- ------- ------- ------- ------- ------- ------ ------
A1 Active Trk10 Blocked Yes Failure 0 299
A3 Active Trk11 Blocked Yes Failure 0 300
A5 Active Trk12 Blocked Yes Failure 0 301
After disable and enable the links became activ.
LACP Trunk Port LACP Admin Oper
Port Enabled Group Status Partner Status Key Key
---- ------- ------- ------- ------- ------- ------ ------
A1 Active Trk10 Up Yes Success 0 299
A3 Active Trk11 Up Yes Success 0 300
A5 Active Trk12 Up Yes Success 0 301
Why did this run automatic? What is happend? Did we anything forgotten?
Thank a lot!
Matthias
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2012 07:12 AM