- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Procurve 2848 Switch
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2016 01:23 PM
10-06-2016 01:23 PM
Procurve 2848 Switch
I have a number of the HP2848 switches. I'm getting massive dropped packet loss (millions) with certain ports that are configured (perhaps incorrectly) as trunks by my predecessor. The VLAN that they're assigned to isn't configured for jumbo frames. However, SolarWinds says that they're set for jumbo frames. I've even logged into the switch, entered VLAN mode and executed a "no jumbo" command. The switch accepted it with no complaints, but nothing has changed.
Please advise. Thanks in advance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2016 09:55 PM
10-06-2016 09:55 PM
Re: Procurve 2848 Switch
On (some) Comware based (your is not Comware based, it's ProVision based), AFAIK, globally disabling Jumbo Frame capability (which is enabled by default) requires the Switch to be rebooted.
On involved ports, did you try to verify via CLI the Jumbo Frame still appears as enabled or not? if the command was successful but the Jumbo appears still enabled instead of being disabled maybe a Switch reboot is required for that setting to change effectively.
A look at Switches' configurations (especially the section regarding ports used for inter-Switch trunking) would be benefical plus providing more informations about your exact network topology (at least inter-Switch links) and Switches' software status.
I'm not an HPE Employee