Routing not working as expected on 2930F-48G

[KoenR · Accepted solution]

So I went back to factory settings and started with the simplest configuration possible I can imagine:

; JL260A Configuration Editor; Created on release #WC.16.07.0002
; Ver #14:01.4f.f8.1d.9b.3f.bf.bb.ef.7c.59.fc.6b.fb.9f.fc.ff.ff.37.ef:02
hostname "Aruba-2930F-48G-4SFP"
module 1 type jl260a
ip routing
snmp-server community "public" unrestricted
vlan 1
name "DEFAULT_VLAN"
no untagged 1-2,16
untagged 3-15,17-52
ip address 192.168.1.27 255.255.255.0
ipv6 enable
ipv6 address dhcp full
exit
vlan 2
name "servers"
untagged 1-2
ip address 192.168.2.27 255.255.255.0
exit
vlan 5
name "administratie"
untagged 16
ip address 192.168.0.27 255.255.255.0
exit

With this setup both hosts on different VLAN's can ping eachother. 

[nateliv]

Adding an update on the loop protection issue. 

I've done several additional rounds of testing and found that loop protection does work...eventually.

Creating a loop in an unmanaged switch off of port 1/46 loop brings down port 1/46 and, after the set number of disable seconds, brings the port back up. Loop protection DOES then bring the port down again, but only after about 10 minutes of active looping and impacted network operations.