Aruba & ProVision-based
Showing results for 
Search instead for 
Did you mean: 

Routing not working as expected on 2930F-48G

Go to solution
Occasional Advisor

Re: Routing not working as expected on 2930F-48G

So I went back to factory settings and started with the simplest configuration possible I can imagine:

; JL260A Configuration Editor; Created on release #WC.16.07.0002
; Ver
hostname "Aruba-2930F-48G-4SFP"
module 1 type jl260a
ip routing
snmp-server community "public" unrestricted
vlan 1
no untagged 1-2,16
untagged 3-15,17-52
ip address
ipv6 enable
ipv6 address dhcp full
vlan 2
name "servers"
untagged 1-2
ip address
vlan 5
name "administratie"
untagged 16
ip address

With this setup both hosts on different VLAN's can ping eachother. 

Occasional Visitor

Re: Routing not working as expected on 2930F-48G

Adding an update on the loop protection issue. 

I've done several additional rounds of testing and found that loop protection does work...eventually.

Creating a loop in an unmanaged switch off of port 1/46 loop brings down port 1/46 and, after the set number of disable seconds, brings the port back up. Loop protection DOES then bring the port down again, but only after about 10 minutes of active looping and impacted network operations.