HPE Community
HPE Aruba Networking & ProVision-based
1849790 Members
2468 Online
104044 Solutions
New Discussion

Re: SNTP inside a Network with a 2810

 
PeterKna
Occasional Contributor

‎06-22-2017 09:30 PM

‎06-22-2017 09:30 PM

SNTP inside a Network with a 2810

Hey guys,

I am configureing SNTP for my switches at the moment. I have no problems doing it for my 2910al. He is pulling a time from the server but my 2810 not. I cannot even reach the server with a ping. The replie is that I cannot reach the destination from this vlan.

The 2810 is directly connected with the 2910al. The 2910al routes to the internet.

Any ideas?

Thx

0 Kudos
1 REPLY 1
Vince-Whirlwind
Honored Contributor

‎06-25-2017 08:55 PM

‎06-25-2017 08:55 PM

Re: SNTP inside a Network with a 2810

Does the 2810 have a default route on it?

Is the 2810 one of those switches where you have to actually have to configure something like "VLAN nnn management-vlan"?

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.