- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Re: STP Config tbetween Cisco and Procurve
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2015 04:15 PM
12-30-2015 04:15 PM
STP Config tbetween Cisco and Procurve
Hello,
I am working on a project to deploy Cisco switches in an HP Procurve environment. Currently, there is a Procurve E8206zl as the Core switch with STP being disabled. I am planning on connecting a new Cisco Core switch, with PVST+ enabled and the Bridge priority is set is 4596., to the E8206. My question is if STP on the E8206zl is disabled, will this switch have a default bridge ID? If so, what is it and what command can I use to view it?
Much appreciated.
Best, ~zK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2015 11:13 PM
12-30-2015 11:13 PM
Re: STP Config tbetween Cisco and Procurve
default bridge ID is 32768. (see config for spanning tree related commands)
However, when stp is disabled, the switch does not participate in spanning tree, so there's no need to worry about it's bridge ID.
Note: For best Cisco-HP interoperability, consider using MSTP instead of PVST+
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2016 10:43 AM
01-04-2016 10:43 AM
Re: STP Config tbetween Cisco and Procurve
Thanks for the reply.
Much apprecited.
Best, ~zK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-06-2016 05:32 PM
01-06-2016 05:32 PM