Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

Slow fibre connection between 2 switches

 
SOLVED
Go to solution
Highlighted
Eric99
Occasional Visitor

Slow fibre connection between 2 switches

Hello all,
 

I was wondering if you can advise why my fibre connection between two switches shows only 1000 Mbps.

Both switches are around 200 meters away from each other. Switch 1 is HP Switch 5406zl (J8697A). Switch 2 is 2910al-24G-PoE. I thought I can expect at least 10000Mbps link per port.

Switch 1 ports view: https://drive.google.com/open?id=1OzANuR0GYkMFu0PSxLxGIhGp4w7AHPvv

Switch 1, Port 23 and 24 - Port Table: https://drive.google.com/open?id=1AqBfj5Z5xvGGKUAElstDeKFbg_Xtz_Fk

Switch 2 ports view: https://drive.google.com/open?id=11W7_HGfznndy4rdv-VGXklM6bkDStp09

Switch 2, Port 23 and port 24 - Port Table: https://drive.google.com/open?id=1lTdb_hokhv5MyK3VtFvFbvjz5EfAeKn6

1 REPLY 1
parnassus
Honored Contributor
Solution

Re: Slow fibre connection between 2 switches

Dear Eric99,

You expect too much from SFP Transceivers. They are really giving you the maximum correct link speed they are engineered to. To reach 10Gbps you need to enter into the SFP+ world.

Short answer: no support of any SFP+ Transceiver (10Gbps=10000Mbps) on your peer switch HP ProCurve 2910al...so you are on a dead end road.

Long answer: you NEED a particular module (four 10Gbps SFP+ ports...please notice the "+") on HP ProCurve 5406zl side...you're just using SFP Transceivers (1Gbps=1000Mbps) on SFP Ports of a 20+4 Module...which is not suitable to support any SFP+ Transceiver (like the J9150A that is a LC Short Range).

So you links are OK from the speed standpoint...considering the SFP capabilities you have on both ends. The step to 10Gbps requires an upgrade from SFP to SFP+ (involving not only Transceivers...but also the ports' capabilities provided by involved switches).

A suitable module on HP ProCurve 5406zl would be the four SFP+ ports HP ProCurve 4-Port 10GbE SFP+ zl Module (J9309A) which provide and support SFP+...instead it seems to me that you're just using the HP ProCurve Switch zl 20-Port 10/100/1000 + 4-Port Mini-GBIC Module (J8705A)...which provide and support only SFP.