HPE Community
Aruba & ProVision-based
1753844 Members
7763 Online
108806 Solutions
New Discussion юеВ

Re: Some ports w/no lights on 2810-24g J9021a

 
papajon_0s1
Occasional Contributor

тАО05-06-2019 09:56 AM - edited тАО05-06-2019 11:30 AM

тАО05-06-2019 09:56 AM - edited тАО05-06-2019 11:30 AM

Some ports w/no lights on 2810-24g J9021a

Hello,

We have an old 2810-24G J9021A ProCurve switch that is acting very odd. Even after I factory restored the switch,  some ports will work and others no lights at all. I recently updated the firmware, but it was working ok as far as I am aware. Any thoughts on that or has this old switch finally had it?

Jon

0 Kudos
2 REPLIES 2
HappyBiswa
Advisor

тАО05-12-2019 06:40 AM

тАО05-12-2019 06:40 AM

Re: Some ports w/no lights on 2810-24g J9021a

Hi

This looks like a hardware failure . 

 

Thank You

I am an HPE Employee
0 Kudos
Nalla_VS
Occasional Advisor

тАО09-04-2019 01:24 PM

тАО09-04-2019 01:24 PM

Re: Some ports w/no lights on 2810-24g J9021a

Hi,

Please check the MDI and MDIX are having correct settings on the ports which are not working. Also can you post the Logs if you have any? And from which version to What version you have done firmware Upgradation ? After upgradation are you seeing the Lights on previously effected ports ?

I am a HPE Employee
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.