Trouble removing connection-limit on 5400zl

[Pajje]

Hello!

I have 3 5400zl switches that we have upgraded to K.16.02.0012.

I now have to change some trunks but is not able to. I get the following error:
A mesh or a trunk cannot be configured on connection-rate enabled ports.

I the tried to remove connection-rate from the port and get this error:
Module not present for port or invalid port:

I'm i a catch-22 moment here.

Is there a way to get around this without having to reset all 3 switches and load the configuration again?

B/R
Per-Åke

[parnassus]

Did you tried with no filter connection-rate <port-list> command and the result was that error message?