HPE Community
Aruba & ProVision-based
1752794 Members
5852 Online
108789 Solutions
New Discussion

Trunk mode with HP Switches

 
fga76
Occasional Advisor

‎10-09-2017 01:33 PM

‎10-09-2017 01:33 PM

Re: Trunk mode with HP Switches

My network drawing is not that accurate. SW3 and SW4 are acting as access switches as well. I have users, printers and access point on that switch. Those are not distribution switch only.

So are SRV01 and SRv02. Those switches do not have end user nor printers connected to it. But I have Internet link, storage and servers. They are note purely core switches. They act also as access switches.

That doesn't matter at all, right?

I am getting very confused about this... :-)

 

f_almeida
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.