Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

Vlan 50 with ip address and no untagged ports

 
Collector

Vlan 50 with ip address and no untagged ports

Hi all, 

I am having this situation and I don´t  know if it have sense. 

In HP 8206zl switch I have one VLAN (between others) like this: 

vlan 50

ip address 192.168.50.1 255.255.255.0 

untagged ethernet A1 

exit

*Interface A1 has no ethernet connected. It is empty.  

If I made a "ping" to the ip address 192.168.50.1 from other machine in the network it answers ICMP. 

But...if I quit the port A1 from vlan 50, and I put untagged on VLAN1  the ip 192.168.50.1 does not respond.

¿It´s normal? This IP address is gateway for one server in my network and pass through interface A20-A24 (trunk trk1). 

 

Thanks in advance,

 

Txomin

 

 

3 REPLIES 3
Honored Contributor

Re: Vlan 50 with ip address and no untagged ports

Hi, can you clarify "...from other machine in the network" part?


I'm not an HPE Employee
Kudos and Accepted Solution banner
Collector

Re: Vlan 50 with ip address and no untagged ports

Sure!

A machine located in one switch attached to this one by an LACP trunk.
Respected Contributor

Re: Vlan 50 with ip address and no untagged ports

On some switches it's normal for a L3 interface to go down, if there's no single port in the VLAN active.

otoh, this shouldn't happen when VLAN 50 is active on a trunk to another switch.