HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

What is default size of mtu in HP procurve 2530

 
Omarrsd
Advisor

What is default size of mtu in HP procurve 2530

Dear all
I would like to know that what will be the Default size of mtu in HP procurve switches 2530,2910 if jumbo frame is disable ?? and what is the command to know the configured size of mtu.
Thanks & Regards
3 REPLIES
GuruP
Valued Contributor

Re: What is default size of mtu in HP procurve 2530

"Show jumbos" displays the configured values

HP-2530-48G-2SFPP(config)# show jumbos

 Jumbos Global Values

  Configured :  Max Frame Size :  9216      IP-MTU :  9198
  In Use     :  Max Frame Size :  9216      IP-MTU :  9198

HP-2530-48G-2SFPP(config)#

Omarrsd
Advisor

Re: What is default size of mtu in HP procurve 2530

it means current size of mtu is 9198 not 1500 ? Right ? 

Linkk
Frequent Advisor

Re: What is default size of mtu in HP procurve 2530

You have to enable Jumbo frames on a VLAN basis. The standard mtu is 1522, I believe.

Unfortunately I couldn't find any official documents on that.

Also note: 10/100 Mb/s interfaces can not use frames bigger than 1522