HPE Community
Aruba & ProVision-based
1753864 Members
7512 Online
108809 Solutions
New Discussion

aruba 2920 has both ntp and sntp configured, how to remove one or the other??

 
Tom Lyczko
Super Advisor

‎07-20-2017 12:40 PM

‎07-20-2017 12:40 PM

aruba 2920 has both ntp and sntp configured, how to remove one or the other??

Just recently installed an Aruba 2920 switch.

I did SNTP in the menu section, NTP on the command line.

Config report shows both ntp and sntp configured.

How do I get rid of one or the other??

Can sntp settings use a fqdn?? or is it required to use an IP address??

Thank you, Tom

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.