Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

port-channel lacp fallback on HP Procurve

 
nortlov
Occasional Visitor

port-channel lacp fallback on HP Procurve

Hello All. Is there such option on HP Procurve swithes? I need it for PXE booting to work

Thanks in advance

2 REPLIES 2
HP-Browniee
Respected Contributor

Re: port-channel lacp fallback on HP Procurve

Hello

You can use following command in the switch:

Here you create a port-channel with port 1/1 and 1/2, you name it trk1 and you enable lacp.

trunk 1/1,1/2 trk1 lacp

If you want to allow vlans on this port-channel, you can't use these ports anymore, but you will need to use trk1, for example.

vlan 10
tagged trk1

 

nortlov
Occasional Visitor

Re: port-channel lacp fallback on HP Procurve

Hello, thank you for answer, but i mean i need this interfaces as trunk, and trunk does work, but at first one of this interfaces should work as standalone link for PXE boot (PXE can't use trunk) and when system is booted and lacpbdu is in operation again, trunk should be up again. Other vendors have for example this command port-channel lacp fallback to work for this behavior.

So if interface doesn't receive lacpbdu it should not block the port, but works as standalone interface.