Aruba & ProVision-based
Showing results for 
Search instead for 
Did you mean: 

"router vrrp" does not enable vrrp on 5412r

Occasional Visitor

"router vrrp" does not enable vrrp on 5412r

Hi Ladies and Gents,

i have two 5412r zl2 JL001A with 15.17.005, the new model.

After setting up Vlans and trunk to the partner switch i am not able to enable vrrp.

After entering the command " router vrrp" and check  i get

SW01-ZGR(config)# sh vrrp config global

 VRRP Global Configuration Information

  VRRP Enabled                             : No          
  Traps Enabled                            : Yes         
  Virtual Routers Respond To Ping Requests : Yes
  VRRP Nonstop Enabled                     : No    

Ip routing is on. What are possible causes for this? im shure i miss something.

Any help would be highly appreciated.Thank you.

regards Ralf

This is the current conf:

sh ru
Running configuration:
; J9851A Configuration Editor; Created on release #KB.15.17.0005
; Ver #08:02.ff.f7.fc.7f.ff.3f.ef:ae
hostname "SW01-ZGR"

module A type j9990a
module B type j9986a
module C type j9986a
module D type j9986a
module E type j9546a
module F type j9546a
trunk F1-F3 trk1 lacp
ip routing
interface F1
   name "Trunk to SW2-ZGR"
interface F2
   name "Trunk to SW2-ZGR"
interface F3
   name "Trunk to SW2-ZGR"
snmp-server community "public" unrestricted
   ip address dhcp-bootp
router vrrp
vlan 1
   name "DEFAULT_VLAN"
   no untagged A1-A20,A23-A24,B1-B24,C1-C24,D1-D21,E1-E8,F4-F8
   untagged D22-D24
   tagged A21-A22,Trk1
   ip address
vlan 88
   name "GRID"
   untagged A1-A20
   tagged Trk1
   ip address
vlan 89
   name "SAN"
   untagged A23-A24,B1-B24,C1-C24,E1-E8,F4-F8
  tagged A21-A22,Trk1
   ip address
vlan 113
   name "ADC"
   untagged D21
   tagged A21-A22,D22,Trk1
   no ip address
vlan 114
   name "BROWSER"
   untagged D1-D20
   tagged A21-A22,Trk1
   no ip address
spanning-tree Trk1 priority 4
spanning-tree config-name "RBB"
spanning-tree config-revision 1
spanning-tree instance 1 vlan 1 88 89 113 114
spanning-tree instance 1 priority 0
spanning-tree instance 1 Trk1 priority 4
spanning-tree priority 0
no autorun
no dhcp config-file-update
no dhcp image-file-update
password manager



Occasional Visitor

Re: "router vrrp" does not enable vrrp on 5412r

I found the reason, at least i think...

if one wants to enable vrrp on the new 5412r switches with 15.17. SW the command differs to the older Sw versions!

i have to enter " router vrrp IPv4 enable"

in distingtion to " router vrrp enable".