voice vlan 2510

[freddy13]

Hi...

Can I configure a voice vlan in a hp 2510 48G??

[Richard Litchfield · Accepted solution]

yes, from the VLAN config you can put in the voice command.

Is that what you were asking though?

[freddy13]

Yes. Thanks.

You solved my question.

[moodrak]

I am having switch 2510G 24-port and on voice command a recieved

Invalid input: voice

[paulgear]

Hi moodrak,

Are you sure you're in VLAN context?   e.g.

vlan 100

   name voip

   voice

[moodrak]

yes

HPG-1(vlan-3)# voice
Invalid input: voice

[paulgear]

Hi moodrak,

It appears from the manuals (http://www.hp.com/rnd/support/manuals/2510.htm ) that the 2510 doesn't actually support the voice command.

On supported switches, the voice command does the following:

• enables LLDP-MED
• sets the 802.1p priority to 6 ("qos priority 6")
• sets DSCP values to EF
• transmits the VLAN id to the end device

So probably the closest equivalent for the 2510 is just setting "qos priority 6".

[moodrak]

And 2510 doesn't support VLAN QoS.

[paulgear]

Hi moodrak,

The manual i have for 2510s says that they support both DSCP passthrough mode and VLAN QoS. Perhaps you're on an older firmware version?