HPE Community
Automated Backup
1753520 Members
4627 Online
108795 Solutions
New Discussion юеВ

"no drive" displayed on DLT 718 autoloader

 
tim tye
New Member

тАО06-11-2002 12:32 PM

тАО06-11-2002 12:32 PM

"no drive" displayed on DLT 718 autoloader

I have a HP 718 DLT autoloader that is displaying the message, "no drive". The backup software will not work as it says there is no drive as well. I cannot find any resolution to this.

Please advise. Thank you very much.
0 Kudos
2 REPLIES 2
Stephane Bernou
Occasional Contributor

тАО06-12-2002 01:38 AM

тАО06-12-2002 01:38 AM

Re: "no drive" displayed on DLT 718 autoloader

Hello,
Did you connect all Scsi cable to the back of the autoloader, and the terminator?
best regards,
0 Kudos
CA628575
Trusted Contributor

тАО06-12-2002 04:54 AM

тАО06-12-2002 04:54 AM

Re: "no drive" displayed on DLT 718 autoloader

This is most likely a hardware problem. Take a look at the following thread: http://forums.itrc.hp.com/cm/QuestionAnswer/0,,0x016d42308663d611abdb0090277a778c,00.html
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.