HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

4 port mezz cards .... how are the chips mapped.

 
Adrian Clint
Honored Contributor

4 port mezz cards .... how are the chips mapped.

The four port mezzcards I believe are two dual port chips.

Does anyone know if ports 1&2 3&4 are the two chips or 1&3 & 2&4?
2 REPLIES
Rob Buxton
Honored Contributor

Re: 4 port mezz cards .... how are the chips mapped.

The port mappings are shown in the tech guides for the Blade Chassis themselves.
It's easiest to get hold of the guide for whatever chassis you have and look at that.
Adrian Clint
Honored Contributor

Re: 4 port mezz cards .... how are the chips mapped.

Rob,

I dont want to know how the mezz to interconnect ports are mapped.

I want to know how the chips are mapped to the ports - on the mezz card.

I am assuming a chip for ports 1&2 and the other chip for 3&4.

In a VMWare environment ... if I have to have two VLANS on the same mezz I want them using different chips.