HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Access and Configure HP OA (C7000) from windows

 
ginigangadharan
Occasional Contributor

Access and Configure HP OA (C7000) from windows

Hi,

Could anyone advice, if any option/software to access HP OA from windows/linux ? Something like for iLO - HP Lights-Out Online Configuration utility (HPONCFG)

Note: I am not taling about ssh/GUI via web browser.

4 REPLIES
Torsten.
Acclaimed Contributor

Re: Access and Configure HP OA (C7000) from windows

The default methos is browser or CLI, even serial.

Have a look at OneView too.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
ginigangadharan
Occasional Contributor

Re: Access and Configure HP OA (C7000) from windows

Thanks @torsten,

Yeah, oneview is good option but here not applicable  as I have issue with a Bladechassic at remote site :)

Thought there will be something like iLO software for Windows/Linux.

Enclosure is accessible via OA2 IP and able to login but thats in "Standby" mode. And when we try to change "Standby to Active", it will say "swtiching" but nothing will happen; OA2 still in standby mode.
Seems, we need to send an engineer onsite :(

Torsten.
Acclaimed Contributor

Re: Access and Configure HP OA (C7000) from windows

Assuming you have 2 OAs, one is active, one is standby.

Not sure if it works, but IMHO even the standby should be able to run a 'showall'.

 


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
ginigangadharan
Occasional Contributor

Re: Access and Configure HP OA (C7000) from windows

Yes, got both OAs with IP configured. Seems 1st OA not reachable due to different VLAN and might be removed VLAN from access list. Standby is with another VLAN and accessible. Yes, I am able to see all configurations but unable to change anything.. and not able to make OA2 active.

We are checking with DC Network team to trace the VLAN issue.