After Windows Splash screen - black screen on BL460

[Eric Sabo_1]

After reboot our BL460 right before the Windows Splash screen the screen in iLO goes to a black screen. Does anyone have any suggestion to what could be the issues with these blades, it happened to four blades after they were rebooted.

[Jan Soska]

hi, have you tried turn it off and on again? :) Or remove from chasis and put it back.

Jan

[Pieter 't Hart]

I would check the FW of the blade against the FW of the chassis/management module.

[Mike Schreiner]

Sounds like firmware to me.

[kris rombauts]

Eric,

did this worked fine before ?, because what you are using to look at the console is the IRC feature (Integrated Remote Console) right ?

I think you need the iLO adv. license in order to have the full graphics redirection feature enabled, if not, it only shows the non graphical boot part of the OS and gives a black screen once the console switches to the full graphics mode (aka splash screen ?)


HTH

Kris