BladeSystem - General

After move HP VC flex fabric modules to other bays I can not access VCM

 
SOLVED
Go to solution
peyrache
Respected Contributor

Re: After move HP VC flex fabric modules to other bays I can not access VCM

Good thanks for this feedback
JYP
John Trunik
Occasional Visitor

Re: After move HP VC flex fabric modules to other bays I can not access VCM

Great job fixing this issue!

I had this same issue EXCEPT:  When I saw the message that the Active VC was not in this bay, I connected to what I thought was the backup VC, and tried to type my ID and password.  It makes perfect sense to me that you saw the message that the OA must have been replaced or set back to factory, because my ID and password didn't work.  Now, my question,

Can I fix this issue without reconfiguring the VC Domain from scratch?  Maybe, if I reset one VC module to factory defaults, then let it resynch with the other module I won't lose my settings?  Or maybe if I do them one at a time, I won't lose my settings?

Rajnayak
New Member

Re: After move HP VC flex fabric modules to other bays I can not access VCM

I am not able to Loginto VC after reset.

Also not able to see the VC console in OA web.

How do I do a Factory reset on VC?

 

Rajnayak
New Member

Re: After move HP VC flex fabric modules to other bays I can not access VCM

also not at all getting VCM web-interface from the VC IP.

I am able to only Ping VC nothing else is possible