HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Alertmail not being sent on C3000 blade system

 
Ed_Green
Occasional Visitor

Alertmail not being sent on C3000 blade system

Hi,

I am trying to configure a C3000 blade chassis for email alerts and its all set up in terms of the SMTP server (MS exchange) IP has been entered and the domain and the email address that we want to use for alerts.

When clicking the send test alert mail button it says that it has sent a test mail but nothing comes through and the system log has an entry "Alertmail: Failed to send AlertMail to" followed by the email address that we want to use.

We have added the IP of the OA interface to the exchange server's allowed relay list to see if that made a difference but it didn't.

The firmware of our C3000 is 2.32 are there any known issues with alertmail on this firmware?

Sorry for the long post and thanks for reading and any ideas would be appreciated.
2 REPLIES
Sobhan Majumder
Occasional Advisor

Re: Alertmail not being sent on C3000 blade system

Hi Ed,

Configure one pc with the same ip address of active OA. From that PC try to telnet to SMTP ip with the port no 23. May be the ip of your OA is blocked to access SMTP port from the firewall or etc.
Ed_Green
Occasional Visitor

Re: Alertmail not being sent on C3000 blade system

Hi Sobhan, thanks for your suggestion.

I did think that there could be a firewall involved after I submitted my query.

I will have a look at the firewall to see if it is allowing SMTP traffic.