BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

I have sixteen (fully populated) BL465c G5 in a c7000 enclosure.

I just updated the blade servers with firmware CD 8.70. Then I updated the BIOS to A13 2009.12.08

The virtual connects have the following firmware:
Six HP 1/10Gb VC-Enet Module - 2.10
Two HP 4Gb VC-FC Module - 1.32

On Board Administrator: 2.51 May 28 2009

After completing the updates on the blade servers with firmware CD 8.70 and BIOS update, I am getting the following messages on four of my blade servers: "iLO network configuration problem, check connectivity to iLO default gateway"

I seem to be able to connect fine with no problems.


On one of the blade servers, I am not able to get it to "auto-login" or have the single sign on working. I connect to iLO directrly and it seems I am missing the "OA Administrator" account. How do I go about re-creating this or get the single sign on to work?

I have searched other threads and tried the "server reset "bay#" command from OA and I have physically pulled out the blade sever and re-seated with no results.

I would appreciate any help.
4 REPLIES
gregersenj
HPE Pro

Re: Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

In most cases

Close you browser, and login the OA again.

You also might ha´ve to clear the browser cache.

Also upgrade the OA FW to 2.60.

BR
/jag

Re: Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

Hi gregersenj,

I tried clearing the cache and using browsers from different workstations. It did not help.
I would like to avoid upgrading the OA firmware until I resolve this first.

This problem is starting to grow on other blade servers as well.
Nikolai Schlabitz
Occasional Visitor

Re: Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

Updated the OA firmware to 3.0 and this issue was resolved
The Brit
Honored Contributor

Re: Auto Login failure & "iLO network configuration problem, check connectivity to iLO default gateway"

iLO configuration and communication is achieved via the OA. I would follow the advice and upgrade OA (to at lease 2.60).

It is very likely that the problem lies in the older OA firmware.

Just my opinion!

Dave.