BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

BL25 hangs on SAN boot right after installation

Chris Rosan
Valued Contributor

BL25 hangs on SAN boot right after installation

I've got 2x BL25's, and a BL45, both hooked up to an EVA8000.

I finally managed to get it to install the OS (after another ilo/ATI/redhat problem), but now it hangs when it goes to boot from the "C:", which i believe is the "other boot devices" such as the fibre card.

Any ideas?
2 REPLIES
Chris Rosan
Valued Contributor

Re: BL25 hangs on SAN boot right after installation

BTW

I've done everything AND MORE according to the attached document from HP support.

Hosts are set as "linux" hosts in Command View for EVA, and have also tried "SunSolaris" to no avail.
Koopa
Frequent Advisor

Re: BL25 hangs on SAN boot right after installation

Hello,

 

I could be wrong as i have limited knowledge of the software side of things, but when it hangs at boot from c is that in the post? If so you need to go in the RBSU and make sure your fibre card boot is he first thing in the list. I always get this bit confused, but there is 2 boot orders in the RBSU and im sure only one of them shows the fibre card, just make sure its the first one, and see how that goes

 

Thanks

 

Koopa79