BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

BL35p power on Problem

 
Arman Obosyan
Frequent Advisor

BL35p power on Problem

Hi,
One of my BL35p have power on problem, I cheek ILO logs and found this message:

Critical Rack Infrastructure [NOT SET] [NOT SET] 1 Server Blade Enclosure Inadequate Power To Power On: Lost Redundant Power (Enclosure Address 0000, Slot 10)
10 REPLIES
Raghuarch
Honored Contributor

Re: BL35p power on Problem

Hi Obosyan,

This message says that the redundancy is lost in the enclosure resulting in inadequate Power To Power On.

Does any of the Power supplies fail in the Enclosure?

Regards,
Raghuarch
Arman Obosyan
Frequent Advisor

Re: BL35p power on Problem

All power modules are online, and other blades are up and runing,

After moving problem blade to comm room B and attach it to Enclousure B in comm room B and try to power on I got the same message :(
Raghuarch
Honored Contributor

Re: BL35p power on Problem

Hi Obosyan,

Was it on before? what do you think made it to Go OFF.

when you try to manually power it on is the power LED glowing Amber.

Try reseting the ILO once. I observed one of my servers also have the Entry in the Syslog but i am able to power them ON using ILO.

Regards,
Raghuarch
Arman Obosyan
Frequent Advisor

Re: BL35p power on Problem

Insert BL in bay, LED: amber, after 4-10 seconds its light RED

and one of the BLADEs start and works fine but after 10-20-40 minute power off, no light just power of, and in system their message that system shutdown unexpected
Raghuarch
Honored Contributor

Re: BL35p power on Problem

Hi Obosyan,

Do you have the Latest Rom on the server.
http://h18007.www1.hp.com/support/files/server/us/download/24458.html

You can try updating if you have Earlier version. I recommend a virus Check for the system with unexpected Shutdown.

Regards,
Raghuarch
KENIG
Occasional Visitor

Re: BL35p power on Problem

Hi

I have a same problem on bl20p
thepenquin
Occasional Visitor

Re: BL35p power on Problem

I am having the exact same issue, no apparent reason for the message (no failures obvious). Any updates on a solution?
Arman Obosyan
Frequent Advisor

Re: BL35p power on Problem

No updated solution,
but cause of it that is in one blade enclosure blades (BL35p in my case) are witch different bios, we replace main board of failure blades by warranty.
Upgrade all BL35p bios to latest and all seems work fine at this moment.

As Iâ m understand in one BL Enclosure all blades (bl35p) must be at same bios version.
thepenquin
Occasional Visitor

Re: BL35p power on Problem

Thank you very much for the quick response, I'll ensure all firmware is at the same level.
Liparoti, Juan Pablo
Occasional Visitor

Re: BL35p power on Problem

Hi, I have the same problem with 3 bl35p (i have 3 bl20 and 6 bl35) when i shutdown all enclosure and them turn on 3 of theme don´t turn on, then i have to remove of the enclosure and introduce to startup. The servers startup correctly and never shutdown. The bios is the same in all server.
Thank