BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

BL45p G1 wont ILO, powers on, but after around 40 mins power off

Koopa
Frequent Advisor

BL45p G1 wont ILO, powers on, but after around 40 mins power off

I have a BL45p that if you connect a screen to, I can see the ILO responds on POST, and I can configre etc. But when the customer connects to the IP address I have set in the ILO. They can't connect. Also if I use the SUVI on the front, I can't connect with the 192.168.1.1 IP. The other curious thing is that it keeps powering off after about 40 mins. I've tried removing the disks, so i doesn't use the OS. So I know its not a OS related fault. Does anyone know if there is some sort of watchdog timer for the ILO, and if the blade doesn't think its working it will power off? any sugestions at what I can try will be much apreciated.
1 REPLY
Vaibhav Gandhi
Frequent Advisor

Re: BL45p G1 wont ILO, powers on, but after around 40 mins power off

Hi Koopa,
Is the customer able to ILO to other blades on this enclosure?
Have you looked at IML Logs (ILO System Logs) do they show any errors?
Blade should not turn itself off, even though its not in use, unless powered down.
I would also suggest to check IML logs on the other blades in this enclosure and check if they indicate any issues.

Cheers!
Vaibhav