HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

BL460c G6 - No video

 

BL460c G6 - No video

Hi,

I'm installing 11 bl460c g6 servers in one c7000. 3 of them wont boot with no video signal output. The power meter for them stays fixed at 509w. In the iLO web page can't change de power mode to dynamic power, is in os control mode and can't change it.
The 8 others are with dynamic power saver and are working ok.

All internal componentes were reseated.
Changed them to different bays also.

Updated the ilo fw to 1.82 with no luck.
Also updated oa to 3.00 and nothing.

Will open a call tomoroow but maybe someone of had already seen this as it is happening with 3 servers.

Thanks

Regards
5 REPLIES
Markus M.
Trusted Contributor

Re: BL460c G6 - No video


Hi Sebastián,

had a similiar problem with new bl495.
Nothing did it, fw upgrade, power off/on, reseat, etc.
Finally I solved it with a server reset via CLI..

Good Luck
Markus

Re: BL460c G6 - No video

Hi Markus,

Thanks for your reply.

Do you mean the reset server command in the OA cli?
If is it, I have already done this also.
If not, please tell me what kind of reset are you taking about.

Thanks

Regards
Markus M.
Trusted Contributor

Re: BL460c G6 - No video


Hi,

yes, the OA cli is meant...
bad to hear it did not work for you.

good luck furthermore.
regards
Markus

Re: BL460c G6 - No video

Problem solved.

Change System Maintenance Switch 6 located on the mainboard to "On" and server started properly.

Regards

Re: BL460c G6 - No video

Set system maintenance switch 6 to on to clear server configuration