- Community Home
- >
- Servers and Operating Systems
- >
- BladeSystem
- >
- BladeSystem - General
- >
- BL460c G6 blades show iLO2 as iLO with a serial nu...
BladeSystem - General
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Categories
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
BL460c G6 blades show iLO2 as iLO with a serial number of ed
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
03-10-2010 08:26 AM
03-10-2010 08:26 AM
BL460c G6 blades show iLO2 as iLO with a serial number of ed
BL460c G6 blades show iLO2 as iLO with a serial number of ed
We have five blades out of 12 recently installed BL460c G6 blades (BIOS 10/1/09, iLO2 1.81) in a C7000 Enc that when you open the System Mgmt Homepage show the iLO2 as iLO under the Mgmt Proc sub category. When you travel that page it states the serial number is ed. These iLO2's came with firmware 1.79 and we updated to 1.81 & I am not sure if this info was proper at that time. Any insight would be greatly helpful. Thinking of bak revving.
- Tags:
- iLO
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2018 Hewlett Packard Enterprise Development LP