BladeSystem - General

BL460c Gen10 no network after update

New Member

BL460c Gen10 no network after update


Last night I performed firmware upgrade on one of our blade servers BL460c Gen10. I used Gen10 Service Pack for ProLiant 2020.09.0. After upgrade my network card is not recgonized. I'm unable to instal ESXi 7.0 because I get "No Network Adapters" meesage.

iLo shows HP FlexFabric 20Gb 2-port 630FLB 

Location Embedded ALOM
Firmware N/A
Status Unknown
I tried eFuse, cold reboot, reflash firmware with same SPP and lower one 2020.03.0 to no avail. 

What else could I do?

Thank you in advance!


Re: BL460c Gen10 no network after update

Does the card gets detected in the BIOS ? If yes, if you are comfortable, reseat the FLB once. If possible try flashing the individual firmware component of the NIC through ILO.  If no, as you have already tried flashing the older firmware, performed Efuse, i recommend to raise a support case with HPE. 

I am a HPE Employee

Accept or Kudo