HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
Showing results for 
Search instead for 
Did you mean: 

BL460c+Virtual Connect

toni osta
Frequent Advisor

BL460c+Virtual Connect

i have a c7000 enclosure with 5 BL460c servers blade inside , in each blade we have installaed a type 1 mezzanine ethernet module , so each bl460c has now 4 network ports ,
i have also 4 VC Enet module 1/10Gb , intsllaed in bay 1 ,2,3and 4 .
- first my question is that , what is the best config of these switches i can use (for redundancy)
and as i am new to these VC switches , note that the switch has 8 uplink ports , so can i use only one port of the switch to connect the 5 blades server ? surely if one port is used in each server only ....
i have worked before with the pass thru module , where each port refer to a network port and cable is assign to it , 16 ports means 16 cables ..
i want to know the difference when using VC switches

thank you
Frequent Advisor

Re: BL460c+Virtual Connect

Here's a couple of pretty detailed articles on the virutalized network differences that might answer your questions.



Honored Contributor

Re: BL460c+Virtual Connect


See also this

"Virtual Connect for Cisco Administrators"

Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi