HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

BL465c G1 Teaming Problem

 
mojo1979
Occasional Contributor

BL465c G1 Teaming Problem

Hi,

I have a remote server setup with teaming on the 2 NIC's. I made the mistake of upgrading the driver for the HP Network Configuration Utility (from 8.55.0.0 to 9.10.0.0), after which the teaming is not working and the only way I can connect to the server is via iLO because the server has lost its IP address. I tried downgrading the driver back to 8.55.0.0 but this won't let me configure teaming -

"the virtual miniport (teaming) driver currently installed is not compatible with the HP Network Configuration Utility software installed. The driver (cpqteam.sys) version must be greater than or equal to version 9.10.0.0. However the version currently installed is 8.55.0.0. Please update the driver or reinstall the teaming software"

I basically want to revert back to the original driver (8.55.0.0), and be able to setup teaming as it was before I made this stupid mistake. Any ideas anyone?

Thanks!
2 REPLIES
Lmm_1
Honored Contributor

Re: BL465c G1 Teaming Problem

It refers to the virtual bus driver, just update drivers to latest version and then NCU to latest version, you can check then the drivers installation log under C:\CPQSYTEM\LOG\log.txt. Also attach the output of the network survey to confirm information, from command promt type hpnetsvy >filename.txt

rgds,
lmm