BladeSystem - General
1745841 Members
4695 Online
108723 Solutions
New Discussion

BL620c Firmware upgrade of Emulex CNA and Qlogic Fiber Channel Failure

 
SOLVED
Go to solution
ahmadamin416
Occasional Contributor

BL620c Firmware upgrade of Emulex CNA and Qlogic Fiber Channel Failure

Hi Experts,

   I have upgraded the firmware of HP BL620c with HP Service Pack for ProLiant version 2015.06.0, kindly find the attached image "Installation- 2015.06.0". It has also upgraded Emulex CNAs and Qlogic Fiber Channel HBA. I am running "solaris 10" as an operating system on this server. The upgrade was successfull and no error were reported but after re-booting the server the BIOS is givng error related to Emulex 10GB UNDI and also HBDA allocation failed, kindly find the attached image "Error after installation-2015.06.0". My operating system is also not booting.

I have tried the latest release of HP Service Pack for ProLiant version 2015.10.0 but now it does not show any formware related to Emulex CNA or Qlogic Fiber Channel kindly find the attached image "Installation 2015.10.0"

I do not know which is the correct version, how to install it and is it supported for solaris ?

kindly help and thanks in advance

3 REPLIES 3
Torsten.
Acclaimed Contributor
Solution

Re: BL620c Firmware upgrade of Emulex CNA and Qlogic Fiber Channel Failure

With an update from version 3.x to version 10.x directly you likely bricked the adapter.

 

Try to boot this image

 

http://h20564.www2.hpe.com/hpsc/swd/public/detail?sp4ts.oid=4194639&swItemId=co_137306_2&swEnvOid=54

this may "repair" the hardware. After this run SPP2015.10 again.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
jorgesoto
Occasional Advisor

Re: BL620c Firmware upgrade of Emulex CNA and Qlogic Fiber Channel Failure

 
I was able to recoved the Emulex, now is back on 10.2.340.22, I am trying to upgrade to 10.5.x.x now.
jorgesoto
Occasional Advisor

Re: BL620c Firmware upgrade of Emulex CNA and Qlogic Fiber Channel Failure

@Torsten.

Perfect, I was able to upgrade using SPP 2015.10.

Thanks again!

Kudos!!!