- Community Home
- >
- Servers and Operating Systems
- >
- BladeSystem
- >
- BladeSystem - General
- >
- Black Screen booting smart start on BL460C
BladeSystem - General
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Categories
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Black Screen booting smart start on BL460C
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-22-2009 09:39 AM
10-22-2009 09:39 AM
Black Screen booting smart start on BL460C
Black Screen booting smart start on BL460C
Hi all,
I'm having a problem booting my BL460C blades to the Smart Start 8.30 disk as well as the FW update disk 8.60.
When I boot the blade from either disk, I get video signal up until the end of the loading countdown and then the screen goes black. I'm using the USB/video dongle to install, not ILO.
There are numerous other threads on this subject but all mention using the latest SS and FW disks as a possible cure, and thats not helping me. Also I've seen where blades with more than 64GB of memory may have issues but mine only have 10GB.
Any ideas? I have 10 of these blades to build and I'm stumped.
I'm having a problem booting my BL460C blades to the Smart Start 8.30 disk as well as the FW update disk 8.60.
When I boot the blade from either disk, I get video signal up until the end of the loading countdown and then the screen goes black. I'm using the USB/video dongle to install, not ILO.
There are numerous other threads on this subject but all mention using the latest SS and FW disks as a possible cure, and thats not helping me. Also I've seen where blades with more than 64GB of memory may have issues but mine only have 10GB.
Any ideas? I have 10 of these blades to build and I'm stumped.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2018 Hewlett Packard Enterprise Development LP