HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
Showing results for 
Search instead for 
Did you mean: 

Blade server ILO extremely slow to respond

Alan Casey
Trusted Contributor

Blade server ILO extremely slow to respond

server BL860c
Integrity ILO 2
Firmware version 3.06

I am trying to get a remote console to this server but the ILO access is ectremely slow taking 10-20 mins to go throuogh each screen.
No errors coming up.
Acclaimed Contributor

Re: Blade server ILO extremely slow to respond

First I would check for correct address settings, e.g. mask and gateway, and for duplicated addresses.

Hope this helps!

There are only 10 types of people in the world -
those who understand binary, and those who don't.

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
kris rombauts
Honored Contributor

Re: Blade server ILO extremely slow to respond


do you mean the response in the CLI (Telnet session) is slow or are you talking about the browser based access via http to the iLO/MP ?

Did you tried to reset the iLO or eventually upgrade to a later version of the firmware (which will also reset the iLO in the end)?
Same goes for the OA, if the iLO reset does not help, a OA reset might clear up this issue, assuming you have this slow response from more then one pc/workstation in your network.

This is the last public available sysfw version for the bl860c blade :


This is however a offline upgrade that does more then just the iLO f/w, it's a bundle that does the serverblade systemfw and iLO fw.