BladeSystem - General
1748252 Members
4089 Online
108760 Solutions
New Discussion

Bonding problem with embedded Emulex NIC

 
qvlatrt
New Member

Bonding problem with embedded Emulex NIC

Hi to all,

 

I have problem with bonding miimon=100.

I have HP 1Gb Ethernet Pass-Thru Modules and Emulex and Broadcom NIC.

 

Bonding with Broadcom NIC is working perfect and with Emulex NIC I have problems:

 

 - When I unplug cable from port Link will staid up (MII Status: up)and traffic will be lost

- WHen I put cable back I have to wait for about 10 minutes that system established physical connection and link become up and start to handle traffic.

 

Have anybody experienced that same situation?

 

Regards

2 REPLIES 2
JKytsi
Honored Contributor

Re: Bonding problem with embedded Emulex NIC

And by Emulex nic You mean the CNA adapter on G7 blades ?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
resrob
Occasional Collector

Re: Bonding problem with embedded Emulex NIC

Same problem here, the adapter does not detect loss of connection. SO: Debian Linux 6.0 (squeeze). Tried updating both firmware and driver: 4.1.402.20, hp-be2net-4.1.402.6-2 (4.1.402.6) respectively.

 

rob