BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

C Class interconnect command line.

SOLVED
Go to solution
C Yates
Advisor

C Class interconnect command line.

Please can someone help? I'm trying to manually configure an ip address on a 4gb brocade interconnect switch using a serial cable and hyperterminal. I've logged into the OA and connected to the relevant interconnect using the connect interconnect , managed to set the ip address and logged out which leaves me at the interconnect prompt. What is the key sequence to get back to the OA prompt to then connect to the next interconnect? It's driving me mad and I can't find any documentation on it.
3 REPLIES
Raghuarch
Honored Contributor
Solution

Re: C Class interconnect command line.

Hi Yates,

The character sequence is
Escape character is '_'

It asks you for the
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode >

Input D it will disconnect the session.

Regards,
Raghuarch
C Yates
Advisor

Re: C Class interconnect command line.

Thanks for the reply.
C Yates
Advisor

Re: C Class interconnect command line.

Close thread.