BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

C3000 Blade Enclosure Incorrectly Reporting Faulty Fan

 
MartyH_1
Occasional Visitor

C3000 Blade Enclosure Incorrectly Reporting Faulty Fan

Hi
I have a C3000 Blade enclosure which occasionally reports that the fan in slot #5 is faulty - it reports this status for about 20 seconds or so and then goes back to normal operation.

The chassis is running firmware version 2.25

Has anyone else encountered a similar sort of error at all?

Cheers
2 REPLIES
Gary Benavides Meza
Trusted Contributor

Re: C3000 Blade Enclosure Incorrectly Reporting Faulty Fan

Is that the only fan that reports the failure #5?? Try to swap the fan to a different position and check if the error follows the fan, if it does might be a fan about to fail.
Peter_174_1
Occasional Visitor

Re: C3000 Blade Enclosure Incorrectly Reporting Faulty Fan

Hi Marty

Did you get this issue resolved?
I have the same problem on a C3000 Chassis. We have already replaced the fan and also the mid plane assembly that the fan connects to, but the problem still happens.

The OA controller is running firmware version 2.50. I am going to upgrade to ver 2.51 (which is the latest).

Regards

Peter