HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
BladeSystem - General
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

C3000 with two Cisco 3020 bladeswitch - Bandwidth bundeling + redundancy?

 
MalteS
MalteS
Occasional Contributor

‎07-12-2012 02:53 AM - edited ‎07-12-2012 02:54 AM

‎07-12-2012 02:53 AM - edited ‎07-12-2012 02:54 AM

C3000 with two Cisco 3020 bladeswitch - Bandwidth bundeling + redundancy?

Hello,

we have a c3000 enclosure with two Cisco Bladeswitchs (IC1 & IC2).

Our Blades are BL460C G1 with dualport mazzaines (HP NC532m Dual Port Flex-10 10GbE Multifunction BL-c Adapter)

 

Is it possible to combine all 4 Ports to one Team that provides: redundancy (failure of one switch or uplink) and bandwitdh bundling (2 gbit? or better 4 gbit?)

 

I can only find documentations about bundeling downstreams that are connected to the same switch, but I need redundancy aswell, if this is possible.

 

 

Best regards

Malte

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.