BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

C7000, Vcutil error : "Unable to communicate with OA IP"

Keijo Koivumäki
Occasional Contributor

C7000, Vcutil error : "Unable to communicate with OA IP"

Hi,

When trying to update C7000 Virtual Connect -modules by VCutil, it gives an error : "Unable to communicate with OA IP." Error comes before validating update.

When start update in VCutil, it creates user vcmuser there, so there's some kind of connection.

I tried to update two similar bladesystem with same firmware and it went ok.

Thank you for Your help,

Keijo
4 REPLIES
Sameer_Nirmal
Honored Contributor

Re: C7000, Vcutil error : "Unable to communicate with OA IP"

Did you check and verify the network connectivity of OA?

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c01375251/c01375251.pdf

marcus1234
Honored Contributor

Re: C7000, Vcutil error : "Unable to communicate with OA IP"

hmm perhaps

hi perhaps worth a look



http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=329290&prodSeriesId=3201263&swItem=MTX-15cda0bebbbc4d8c861a7898f7&prodNameId=3201264&swEnvOID=1005&swLang
=8&taskId=135&mode=4&idx=3

>>>>>>>>some of the fixes mentioned <<<<<<<

* Resolved issue with Healthcheck when run on an enclosure that was not in VC Mode or the primary module could not be found.
* Resolved issue of FC modules failing to upgrade when there are no Ethernet modules in the enclosure.
* Resolved issue were VCSU fails to print error message for extra characters on the command line.
* Resolved issue of Healthcheck -b option was not functioning.
* Resolved issue of VCSU hanging when large/negative values are provided for activation delay options.
* Resolved issue of VCSU upgrading enclosures that were "found" but not "imported".

may be if all interconnect modules reseated and OA rebooted after , then try again..
Keijo Koivumäki
Occasional Contributor

Re: C7000, Vcutil error : "Unable to communicate with OA IP"

Tried with Vcutil 1.4.1, same problem.

Is it possible, that there are hw problem?

Could I change OA-module from system, where VCutil worked, to a system, that gives error when updating with VCutil without interrupting production?

/Keijo
marcus1234
Honored Contributor

Re: C7000, Vcutil error : "Unable to communicate with OA IP"

yes oa is mainly there as a central point of administration,, but when you remove it subsystems etc will go full speed..

but will be ok ..



This is how we thank in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

enjoy goodluck