BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

C7000 enclosure issue

SOLVED
Go to solution
Jan Nielsen_1
Occasional Contributor

C7000 enclosure issue

Hi All,

I have 2 C7000 enclosures and they are connected through the enclosure link.
After upgrading the enclosures firmware to 2.52 we keep getting an alert saying:

"Enclosure, "Blade1", has detected the removal of 1 enclosure from the enclosure link."

And right after that we get:

"Enclosure, "Blade1", has detected the addition of 1 enclosure to the enclosure link"

Has anyone seen this bfore and if Yes how do we fix it ?.

Thanks,
Strunk
7 REPLIES
Michal Kapalka (mikap)
Honored Contributor

Re: C7000 enclosure issue

hi,

i think this is a firmware issue with informational character. ( more informational )


mikap
Jan Nielsen_1
Occasional Contributor

Re: C7000 enclosure issue

So You are saying that this is something that we need to live with ??

/Strunk
Michal Kapalka (mikap)
Honored Contributor
Netwerk en systeembehee
Occasional Visitor

Re: C7000 enclosure issue

Hi,

I updated all enclosures to version 2.60 but we have still the same problem.

Kind Regards,

Ronald Aben
Michal Kapalka (mikap)
Honored Contributor

Re: C7000 enclosure issue

hi,

ok if this problem is still on the c7000,

you should open a HW call to the HP.

mikap
The Brit
Honored Contributor

Re: C7000 enclosure issue

Hi Strunk,
How often is this message being generated?

and, are both of your enclosures upgraded to OA 2.52?? (What was the pre-upgrade version?)

I have similar setup using 2.51, and I dont see this issue.

Dave
Jan Nielsen_1
Occasional Contributor

Re: C7000 enclosure issue

I'm running 2.60 on both enclosures now and i'm still having the issue.

It's random how often it happens. Sometimes 3 times a day sometimes 1 time during a day and then perhaps 4 days with no alarm. and then it starts again.

I was running 2.51 before the upgrade.

/Strunk