- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Can we add IP v4 static route in Onboard Admi...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-24-2020 04:06 AM
тАО09-24-2020 04:06 AM
Can we add IP v4 static route in Onboard Administrator. I can this command for IPv6 but not for IPv4
ADD OA ADDRESS IPV6 [{<bay number>}| ACTIVE | STANDBY] <ipv6 address/prefix
length>
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-24-2020 07:55 AM
тАО09-24-2020 07:55 AM
Re: Can we add IP v4 static route in Onboard Administrator
Configures the OA to IPv4 static mode or DHCP mode.
In STATIC mode, the IP address and netmask are set to the specified <ip address> and<netmask> respectively. These settings take effect immediately. If the gateway address and/or DNSaddresses are not specified, they are cleared. The gateway and DNS address can also be set by usingthe SET OA GATEWAY and ADD OA DNS commands. The command syntax for setting static mode isas follows:
SET IPCONFIG STATIC [<OA bay number>] <ip address> <netmask> [<gateway>[<DNS1 address> [<DNS2 address>]]]
For more information please refer HPE BladeSystem Onboard AdministratorCommand Line Interface User Guide (Page Numder 115)
https://support.hpe.com/hpesc/public/docDisplay?docId=c00702815
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-27-2020 10:01 PM