BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Can you Enclosure Bay IP Address (EBIPA) AutoFill via the CLI?

chuckk281
Trusted Contributor

Can you Enclosure Bay IP Address (EBIPA) AutoFill via the CLI?

Dan was looking for some help with setting Enclosure IP Addresses:

 

******************

 

I know you can do it in the Web GUI, but is there a way to do this in the CLI interface?

 

Setup 1 Server EBIPA entry and AutoFill the rest or some hidden AutoFill switch you add when assigning an EBIPA IP?

 

The current (OCT 2012) CLI Guide has Zero instances of “autofill” and “auto fill” so I am not hopeful.

 

************

 

Chris replied:

 

****************

 

Use the following and it will auto populate:

 

#Set Enclosure Bay IP Addressing (EBIPA) Information

SET EBIPA SERVER 172.20.20.102 255.255.0.0 1-16

SET EBIPA SERVER GATEWAY 172.20.0.1 1-16

ADD EBIPA SERVER DNS 4.2.2.2

ENABLE EBIPA SERVER 1-16

DISABLE EBIPA SERVER 1A-16A, 1B-16B

Save EBIPA

 

Notice the  bay ID’s at the end of the first two lines.

 

****************

 

Any other questions or comments?