HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Cisco modules, how to set management address on fa0

 
bradshr
Frequent Contributor

Cisco modules, how to set management address on fa0

I have a couple of Cisco 3020 interconnects, and our network team want to remotely administer these. How do you set up remote managment on interface fa0? I tried setting an ip address from the enclosure bay IP addressing, but this doesnt work. I assume a local connection is required to do this, and you have to do it from the IOS?

1 REPLY
Steven Clementi
Honored Contributor

Re: Cisco modules, how to set management address on fa0

If I remember correctly, there are 2 management interfaces on the Cisco 3020.  I could be wrong.. I'll have to check the manual.  I don't have one handy to "look" at it physically.

Steven Clementi
HP Master ASE, Storage and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5)
RHCE
NPP3 (Nutanix Platform Professional)