HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuration issue between GbE2c blade switch and dl465C g6 blade server

 
KentinMoline
Occasional Visitor

Configuration issue between GbE2c blade switch and dl465C g6 blade server

I have a C3000 blade enclosure with two GbE2c blade switches installed. i have a DL465c G6 Blade server installed using the two enbedded network ports. These all work correctly. This DL465c server also has a NC360M dual port ethernet module that reports under Windows as two ethernet adapters not connected to a cable. My question is how do i map the NC360m ports to GbE2c switch bay 2 port 6 and port 14?

1 REPLY
Psychonaut
Respected Contributor

Re: Configuration issue between GbE2c blade switch and dl465C g6 blade server

Make sure your mezz card is in slot 1, not slot 2.  Check out page 10 on the setup doc, right side of the page.