Configure ILo2 in a BL460c

[Feljav]

How can I configure static IP for ilo2 in the Onboard Administrator?

[Raghuarch]

You can browse to Enclosure Bay IP Addressing Page in the Onboard Administrator. and configure the static IP.

[Feljav]

I did it, but I received the IP 0.0.0.0

[Feljav]

I put an IP address in a EBIPA address column and I received the following error:

The page content could not be properly loaded. The following reason was reported:
Could not determine the IP address of the management processor for the requested blade.

[Raghuarch]

Did you try Reset your OA and check, it works or not.

[Feljav]

If I do that, I reset the other ilo ip?

[Raghuarch]

NO It just resets the OA. Not the ILos.

[Feljav]

But If I do that, it will restore all of my enclosure's settings?

[Raghuarch]

Reseting the OA through Active OA page doesn't alter Enclosure settings.
If you do a factory Reset then the settings will be affected.

I assume you are having Problem with Only one blade? Correct me if i am wrong.
In the OA syslog Do you see any messages regarding that blade.

[Feljav]

Yes, the problem is with one blade. I can connect to the other blade ilo.
I don't see any message related with the problem. In the enclosure bay ip addressing, I can't change the ilo's ip for that blade. If I used EBIPA, it give me the ip 192.168.1.21 but I can't connect.