HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Configure VC ethernet interconnects on existing enclosure

 
wickman
Advisor

Configure VC ethernet interconnects on existing enclosure

Is there any way to pre-configure two new VC ethernet modules that will be replacing two existing Cisco 3020 switches? I want to minimize downtime if at all possible.

Thanks,
Eric
1 REPLY
HEM_2
Honored Contributor

Re: Configure VC ethernet interconnects on existing enclosure

Not really, unless you have a spare chassis hanging around.

But if you understand VC fairly well, you could use the Command Line Interface (as of FW version 1.20 and up) to create a scripted config.

Here is the CLI reference:

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c01176739/c01176739.pdf

potentially you could have a sort of script written out prior to installing the modules. This may help to minimize downtime.

Remember, to assign server profiles to servers, the servers must be powered off. So regardless, there will be some downtime when migrating from Cisco to VC.