BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Connect GBE2C Blade Switch to Procurve

JRoell
Occasional Contributor

Connect GBE2C Blade Switch to Procurve

Hi,

what is the best practice to configure a Trunk
between a GBE2C Blade Switch and HP Procurve Switches ?
Is it OK to just enable LACP (Active) on the ProCurve Switch-Ports and enable LACP (Passive) on the GBE2C Ports ?
Are there any configuration examples ?
Thanks.
1 REPLY
Adrian Clint
Honored Contributor

Re: Connect GBE2C Blade Switch to Procurve

Hi,

Have a look in the Gbe2c/Cisco compatability guide on the bladeconnect.com website. It may help if you can convert what you need to do on a cisco into procurve commands. I've not seen any specific Procurve/Gbe2 docs anywhere.
http://www.bladeconnect.com/modules.php?name=Web_Links&l_op=viewlink&cid=7

Or check the forums
http://www.bladeconnect.com/modules.php?name=Forums&file=index

Or email Errol or Igor - contacts on the main homepage
http://www.bladeconnect.com/index.php